When you install a new roof, there are a few important steps that you should follow. The first step is to determine where to place the shingles on your roof. You should start with a row of roofing tiles that is square to the roof’s bottom edge and sides. The taller ridge of the roof should face to the right. Then, start to install shingles one ridge at a time. Make sure to use rubber washers to prevent water from leaking through the shingles. Next, place roofing screws along the ridge, spreading them out vertically into two-foot rows.
Another important step in the roof installation process is choosing a professional contractor. Consider hiring a company that has been in business for more than 25 years. Paragon Roofing is a certified, fully-insured company that has been installing roofs throughout the country since 1989. Founded by brothers Steve Smith and David Wortham, the company has installed more than seventy thousand roofs and achieved the highest level of recognition from material manufacturers.
Next, a professional roof installation contractor will design the overall structure of the roof. The rafters and trusses will need to be placed to distribute weight evenly. Improper placement can cause problems with the roof in the future. By ensuring that the roof installation process is done properly, you can enjoy a new roof without the worry of leaks and leaking.
Roofing contractors should also do a final cleanup. After the work is finished, the roofing contractor should clean up all the debris that may have fallen during the installation process. Remember that stray nails and other sharp objects could cause harm to you and your family. To ensure the best possible outcome, the roofing contractor should ensure that the new roof is installed by the manufacturer’s recommended standards.
Another important step is the installation of flashing. Flashing protects the vulnerable joints of the roof. It should extend beyond the roof’s vent hole and stack. Ensure that you install vent flashing over the top and bottom of the row of shingles. Once these steps are complete, you can move on to installing shingles.
Once the shingles are on the roof, you should cover the frame with decking. Using plywood was a common choice, but modern roofs use oriented strand board (OSB) instead. This type of material is made up of thin strips of wood that are held together with wax or resin. Then, a special underlayment is placed under the shingles to keep them in place.
After removing the old roofing, you should inspect the new roof. If you notice any damage, this may indicate the need for a new roof. If you’re unsure whether your roof needs replacement, you can always hire a roofing expert to inspect the roof for you. During this inspection, they will check for dark patches, moss, or algae growth. Additionally, they’ll take note of any wear and tear the roof has experienced over the years. You should have your roof inspected once a year, as well as after a storm.